Victa 4 stroke mower manual




















Protect hands by using heavy duty gloves or a rag to grasp the cutting blade. We recommend that the blade bar, washer and bolt be replaced when changing the blade bar tighten to Nm Ft Lbs. Replace when necessary. Use only genuine replacement parts made and guaranteed by Victa. Can used used with withall all16" 6in mowers. Flat Key key 2. Install the blade adapter on the crankshaft. Refer to the figure above. Place the blade with the part number facing away from the adapter.

Align the washer over the blade and insert the hex bolt. Tighten the hex bolt to Nm Ft Lbs. VICTA recommends that the air filter element and seal ring are replaced annually, or more often in dusty conditions.

Always replace with genuine Victa spare parts. Use of non-genuine spare parts may damage your mower engine, and void the product warranty. Replacing Air Filters Fig. To stop loose material falling into filter body, tilt upper handle so that filter body is up-side down. Remove filter element and seal ring.

Do not use compressed air or wash with any liquid. Examine element for holes, splits or permanent clogging. Replace if necessary. Replace if damaged or permanently crushed. Tilt upper handle back to normal position. Push filter cap on, ensuring teeth engage in slots on filter housing.

Replace it if damaged. Replace it if damaged or permanently crushed. Refit seal to housing. Do not use compressed air or wash the element in any liquid. Examine the element for holes, splits or permanent clogging.

Replace the element if necessary. Refit element to housing. Do not allow the battery terminals to contact metal or conductive surfaces. This will cause a spark sufficient to ignite fuel vapors which may result in fire and injury. Reversing the connections will damage the charger, necessitating replacment. Ensure the recharge socket is securely held inside the protection boot. Only remove the recharge socket from the boot when charging.

Take care when adjusting the handles to ensure the battery harness is not pinched or severed inside the clamps for the upper handle. The lawnmower is provided with a specific charger for the battery and also has a conventional recoil starter with a pull type starter cord.

Only use the charger supplied for recharging as alternative chargers may damage the battery and void the warranty. During periods of non-use, the battery charge will reduce. It is recommended that the battery be charged every six months when not in use.

Should this be exceeded the condition will deteriorate. DO NOT persist starting an engine in poor condition, or with a low charge battery pack. Handle the battery with care.

Do not clean with petrochemicals. Dust with a soft brush and ensure that dust does not collect on the battery terminals, recharge socket or inside the protection boot. Contact your local waste management authority for instruction of safe disposal. First Aid Following these instructions carefully if the batery breaks or cracks and some of its contents are contacted or ingested contact the poisions information centre or call a doctor immediately. Charge the battery for a minimum of 10 hours to 48 hours.

After 48 hours the battery should be fully charged. Un-clip connector located at lower handles then remove battery pack from upper handle. Follow the recharging instructions above. Keystart Battery Store the mower in a well ventilated area, away from any naked flames found in gas hot water heaters. Note: After cleaning, run the engine briefly to dry off the excess moisture before storing. Remove the starter key from the ignition switch of Keystart models and disconnect the battery.

Troubleshooting In small engines generally, difficult starting and erratic running is most often caused by a dirty spark plug. If a new spark plug of the correct type does not restore the engine to proper operating condition, the problem may be solved by reference to the chart below.

You will find the latest Service Centre listing on the Victa website, www. The terms set out below do not exclude rights and remedies implied by a statute which are non-excludable and which may be more extensive than those provided by this warranty.

These centres are staffed and equipped to provide expert service. Express Warranty covers only the replacement, repair or adjustment of parts which fail due to a fault in manufacture. Defective parts will be replaced or serviced by an Authorised Service Centre without charge for labour or materials, subject to conditions. Repairs or adjustments required by normal use or by failure to follow the manufacturer's instructions are chargeable to the owner.

This instruction manual will aid in the assembly, operation and maintenance of your new lawnmower. Please read carefully to ensure safety and the long life of your product. Always replace worn or damaged blades and bolts in sets to preserve correct balance.

Damaged or worn blades and bolts are major hazards. Page 6 Do not create any source of ignition until fuel vapours have dissipated. VICTA supplies a 5 litre fuel can as an optional extra. Plastic containers are unsuitable, except Personal Safety Equipment Recommended safety equipment to wear when working with your lawnmower: A set of ear muffs.

A pair of protective gloves. Handle assembly parts only on self assembled handle 16in models Your lawnmower should include a kit with the following parts. Looped lower handle 2 Handle 2 End Fit one of the bolts through the handle hole from the inside and into the square hole in mounting bracket of the base.

Straight lower handle 2 Nuts Lower handles Black painted S ilver saddle plates saddle plates Page 14 Bolt chassis, from underside. From the topside, place lower handle straight or loop , then one of the black Note the orientation of the mulching plug. Page Aerogrip Handle Assembly 6. Upper handles Assembly Procedure 1 Lay the upper handle across the engine cowl of the lawnmower, with the bend facing down see Fig. Position to locating hole in handle and secure with screw and nut see Fig.

Need help selecting the right Victa lawn mower for you? Use our product selector tool to find the best mower for your needs. With a 19" deck you can get more done with less effort. With an 18" cutting width and a large catcher it's the ideal choice for a small to medium size lawn. Quiet mowing with good power. Along with a Quad Blade Mulching Disk, it's hard to beat.

Expect a great cut whether catching or mulching. Perfect for smaller yards. Petrol power combined with 18V starting technology. The best of both worlds. Push button starting makes this one of our easiest yet! Australia New Zealand. Change Region. New Zealand. Domestic Products.



0コメント

  • 1000 / 1000