Ic-v85 icom manual

Shows operating frequency, channel number or channel names, depending on display type p. Misuse of Lithium-Ion batteries may result in the following hazards: smoke, fire, or the battery may rupture. Misuse can also cause damage to the battery or degradation of battery performance. Use and charge only specified Icom battery packs with Icom radios. Only Icom battery packs are tested and approved for use with Icom radios.

DO NOT hammer or otherwise impact the battery. Do not use the battery if it has been severely impacted or dropped, or if the battery has been subjected to heavy pressure. Battery damage may not be visible on the outside of the case.

Excessive temperatures may also degrade battery performance or shorten battery life. DO NOT expose the battery to rain, snow, seawater, or any other liquids. Do not charge or use a wet battery. If the battery gets wet, be sure to wipe it dry before using.

NEVER incinerate an used battery pack since internal battery gas may cause it to rupture, or may cause an explosion.

Use the battery only with the transceiver for which it is specified. If fluid from inside the battery gets in your eyes, blindness can result. Rinse your eyes with clean water, without rubbing them, and see a doctor immediately. Immediately stop using the battery if it emits an abnormal odor, heats up, or is discolored or deformed. If any of these conditions occur, contact your Icom dealer or distributor.

Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password. NOTE Recommended for optimum use. This device emits Radio Frequency RF energy. Place the unit in a secure place to avoid inadvertent use by children.

D Belt clip Conveniently attaches to your belt. Attach the belt clip with the supplied screws using a phillips screwdriver. To attach the belt clip. Battery pack q w Battery release button. Also, do not mix new and old batteries together. Quick reference guide II. D Basic operation 1. Turning ON the transceiver Although you have purchased a brand new transceiver, some settings may be changed from the factory defaults because of the Quality Control process.

Resetting the CPU is necessary to start from factory default. BEEP T. Adjusting audio output level Rotate [VOL] to set the desired audio level.

Direct frequency input from the keypad is also available. Transmit and receive Push and hold [PTT] to transmit, then speak into the microphone; release to receive. Setting frequency In VFO mode, set the desired operating frequency with other desired settings, such as repeater and subaudible tone. See page iv for a list of available options. TONE 1 P. The offset and repeater tone is not changed by the auto repeater function.

Reset these frequencies, if necessary. S : The squelch closes in short delay. Page Troubleshooting If your transceiver seems to be malfunctioning, please check the following points before sending it to a service center. No power comes ON. The removed cover cannot be used again. Transmit at 7 W High at 4 W Middle 2. Page 78 MEMO Page 79 MEMO This manual is also suitable for: Ic-vt Ic-v85e. Print page 1 Print document 80 pages. Rename the bookmark. Delete bookmark? Cancel Delete.

Delete from my manuals? Sign In OR. Don't have an account? Sign up! Restore password. Upload manual. Upload from disk. Upload from URL. Icom, Icom Inc. This device emitsRadio Frequency RF energy. Extreme caution should be ob-served when operating this device. NEVER hold the transceiver so that theantenna is very close to, or touching exposed parts of thebody, especially the face or eyes, while transmitting.

Thetransceiver will perform best if the microphone is 5 to 10 cm 2 to 4 inches away from the lips and the transceiver is verti-cal. NEVER operate the transceiver with aheadset or other audio accessories at high volume levels. Hearing experts advise against continuous high volume op-eration. If you experience a ringing in your ears, reduce thevolume or discontinue use. NEVER operate the transceiver whiledriving a vehicle. Safe driving requires your full attentionanything less may result in an accident.

This may pose a fire hazard or result in an electric shock. NEVER connect the transceiver to a power source usingreverse polarity. This will ruin the transceiver. If an incorrect connection is made after cutting,the transceiver may be damaged. NEVER operate or touch the transceiver with wet hands.

This may result in an electric shock or ruin the transceiver. NEVER attempt to charge alkaline or dry cell batteries. Beaware that external DC power connections will charge batter-ies inside the battery case. This will damage not only the bat-tery case but also the transceiver. DO NOT operate the transceiver near unshielded electricalblasting caps or in an explosive atmosphere. AVOID the use of chemical agents such as benzine or al-cohol when cleaning, as they can damage the transceiverssurfaces.